Input Supply Voltage: 2.8 V, 1.2 V, 2.5 V to 3.Sensor Technology: Uncooled VOx microbolometer.Non-Uniformity Correction (NUC): Automatic with shutter.

Image Optimization: Factory configured and fully automated.Array format: 80 × 60, progressive scan.Optimum Temperature Range: -10☌ to +80☌.Non-Operating Temperature Range: -40 ☌ to +80 ☌.Mechanical Interface: 32–pin socket interface to standard Molex® socket.Package Dimensions - Socket Version (w x l x h): 11.8 x 12.7 x 7.2 mm.

Control Port: CCI (I2C-like), CMOS IO Voltage Levels.

Output image independent of camera temperature.

Spectral Range: Longwave infrared, 8 µm to 14 µm.Scene Dynamic Range: -10-140 ☌ (high gain) up to 450☌ (low gain) typical.Radiometric Accuracy: High gain: Greater of +/- 5☌ or 5% (typical) Low gain: Greater of +/- 10☌ or 10% (typical).Output Format: User-selectable 14-bit, 8-bit (AGC applied), or 24-bit RGB (AGC and colorization applied).Input Clock: 25-MHz nominal, CMOS IO Voltage Levels.Flir Hadron 640R Flir Lepton Flir Tau 2 Flir Vue Flir Vue Pro Flir Vue Pro R. RunCam 1 RunCam 2 RunCam 3 RunCam 3s Runcam 5. Effective Frame Rate: 8.6 Hz (commercial application exportable) PiCamera High Quality PiCamera Night Vision Picamera V1 Picamera V2.The radiometric Lepton captures accurate, calibrated, and non-contact temperature data in every pixel. With a focal plane array of 80圆0 active pixels, this Lepton easily integrates into native mobile-devices and other electronics as an IR sensor or thermal image sensor. Preliminary support for FLIR Boson has been added and is under development.The FLIR Lepton® 2.5 - Thermal Imaging Module is a radiometric-capable long wave infrared (LWIR) camera solution that is smaller than a dime, fits inside a smartphone, and is less expensive than traditional IR cameras. GetThermal supports all FLIR Lepton variants used with the USB PureThermal 1 Smart I/O Module, including the Radiometric Lepton 2.5 Ultimately, any platform that runs QT 5.7+ and libusb should function with some effort. Success has also been reported on NVIDIA Linux for Tegra. The Wiki tab has instructions for building on Raspbian.

Supported Platformsīinaries are available for desktop Linux (圆4) and Mac OS platforms see the Releases tab on GitHub. This program makes it easy to connect a PureThermal 1 with FLIR Lepton or FLIR Boson to a computer running Mac OS or Linux, including the Raspberry Pi. GetThermal is a cross-platform thermal camera viewer application.

Flir lepton 2.5 raspberry pi